MV Three phase induction motor
Voltage 6600 V, 50 HZ
The generator will be completely dismounted and checked in order to verify the integrity of all its components.
Pyrolitic oven to remove the damaged windings
Preliminary ring test on the stator
CLEANING AND DRYING
Cleaning with specific products and drying in oven with monitored temperature.
At the end of the drying cycle, the insulation test will be repeated with the purpose to verify the effectiveness of drying treatment.
A superficially special paint is applied on to the windings. This paint has high di electric characteristics reinforcement of the winding protection against contamination such as dust dirt moisture.
The bearings will be replaced with others of the same type and pre- lubricated during mounting.
New winding and new magnetic slot cap
Preliminary static checks
No load test
Full load test
Project ClientMELLITAH Oil and Gas
Category Recent Service and Maintenance Projects